Enterasys Matrix 2G4072-52 - Set Spantree Stpmode

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-18 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.6 set spantree stpmode
Use this command to globally enable or disable the Spanning Tree Protocol (STP) mode.
set spantree stpmode {none | ieee8021}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Spanning Tree:
none Disables Spanning Tree.
ieee8021 Enables 802.1 Spanning Tree mode.
Matrix(rw)->set spantree stpmode none