General Configuration Command Set
Setting Basic Device Properties
2-68 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3.19 set prompt
Use this command to modify the command prompt.
set prompt “prompt_string”
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the command prompt to Switch 1:
prompt_string Specifies a text string for the command prompt.
NOTE: A prompt string containing a space in
the text must be enclosed in quotes as shown in
the example below.
Matrix(rw)->set prompt “Switch 1”
Switch 1(rw)->
To Next Page
Loading...
