Security Configuration Command Set
Configuring MAC Authentication
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-99
14.3.7.18 set macauthentication quietperiod
Use this command to enable a reauthentication attempt for failed entries at the period specified in
seconds. Default value is 0 (never).
set macauthentication quietperiod time port-string
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set the macauthentication quiet period to 120 seconds
(2 minutes) on ge.2.1 through 5:
time Specifies the number of seconds between reauthentication
attempts. Valid values are 0 - 4294967295.
port-string Specifies the port(s) on which to set the macauthentication
quiet period. For a detailed description of possible
port-string values, refer to Section 4.1.1.
Matrix(rw)->set macauthentication quiet period 120 ge.2.1-5
To Next Page
Loading...
