Port Configuration Command Set
Setting Speed and Duplex Mode
4-42 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.4 Setting Speed and Duplex Mode
Purpose
To review and set the operational speed in Mbps and the default duplex mode: Half, for half duplex,
or Full, for full duplex for one or more ports.
Commands
The commands used to review and set port speed and duplex mode are listed below and described
in the associated section as shown.
• show port speed (Section 4.3.4.1)
• set port speed (Section 4.3.4.2)
• show port duplex (Section 4.3.4.3)
• set port duplex (Section 4.3.6)
NOTE: These settings only take effect on ports that have auto-negotiation disabled.
To Next Page
Loading...
