Spanning Tree Configuration Command Set
Configuring Spanning Tree Loop Protect Features
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-123
6.2.3.3 clear spantree lp
Use this command to return the Loop Protect status per port and optionally, per SID, to its default
state of disabled.
clear spantree lp port-string [sid sid]
Syntax Description
Command Defaults
If no SID is specified, SID 0 is assumed.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to return the Loop Protect state on fe.2.3 to disabled:
port-string Specifies port(s) for which to clear the Loop Protect feature
status. For a detailed description of possible port-string
values, refer to Section 4.1.1.
sid sid (Optional) Specifies the specific Spanning Tree(s) for
which to clear the Loop Protect feature status. Valid values
are 0 - 4094. If not specified, SID 0 is assumed.
Matrix(rw)->clear spantree lp port fe.2.3
To Next Page
Loading...
