Configuring LACP
Configuring Link Aggregation
4-100 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.5.4.1 show lacp
Use this command to display the global LACP enable state, or to display information about one or
more aggregator ports. Each Matrix Series module provides 48 virtual link aggregator ports, which
are designated in the CLI as lag.0.1 through lag.0.48. Once underlying physical ports (i.e.; fe.x.x,
ge.x.x) are associated with an aggregator port, the resulting aggregation will be represented as one
Link Aggregation Group (LAG) with a lag.x.x port designation.
show lacp [state | port-string]
Syntax Description
Command Defaults
• If state is not specified, aggregator information will be displayed for specified
ports.
• If port-string is not specified, link aggregation information for all ports will be
displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display information for aggregator port 48
:
Table 4-9 provides an explanation of the command output.
state (Optional) Displays the global LACP enable state.
port-string (Optional) Displays LACP information for specific LAG
port(s). Valid port designations are lag.0.1 - 48.
Matrix(rw)->show lacp lag.0.48
Aggregator: lag.0.48
Actor Partner
System Identifier: 00:e0:63:9d:b5:87 00:00:00:00:00:00
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 32768
Attached Ports: None.
To Next Page
Loading...
Need help?
General