Security Configuration Command Set
Configuring RADIUS
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-9
14.3.2 Configuring RADIUS
Purpose
To perform the following:
• Review the RADIUS client/server configuration on the device.
• Enable or disable the RADIUS client.
• Set local and remote login options.
• Set primary and secondary server parameters, including IP address, timeout period,
authentication realm, and number of user login attempts allowed.
• Reset RADIUS server settings to default values.
• Configure a RADIUS accounting server.
Commands
The commands used to review and configure RADIUS are listed below and described in the
associated section as shown:
• show radius (Section 14.3.2.1)
• set radius (Section 14.3.2.2)
• clear radius (Section 14.3.2.3)
• show radius accounting (Section 14.3.2.4)
• set radius accounting (Section 14.3.2.5)
• clear radius accounting (Section 14.3.2.6)
To Next Page
Loading...
