Enterasys Matrix 2G4072-52 - Clear Spantree Bridgeprioritymode

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-35
6.2.1.23 clear spantree bridgeprioritymode
Use this command to reset the Spanning Tree bridge priority mode to the default setting of 802.1t.
clear spantree bridgeprioritymode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the bridge priority mode to 802.1t:
Matrix(rw)->clear spantree bridgeprioritymode