Logging And Network Management Command Set
Configuring RMON
11-74 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.4.19 show rmon topN
Use this command to displays RMON TopN properties and statistics. TopN monitoring prepares
tables that describe the hosts topping a list ordered by one of their statistics. TopN lists are samples
of one of the hosts base statistics over a specific interval.
set rmon topN [index]
Syntax Description
Command Defaults
If index is not specified, information about all entries will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display all RMON TopN properties and statistics. A control entry
displays first, followed by actual entries corresponding to the control entry
:
index (Optional) Displays RMON properties and statistics for a
specific entry index ID.
Matrix(rw)->show rmon topN
--------------------
Index = 1
Status = 1 valid
Owner = monitor
Start Time = 0
HostIndex = 1
Rate Base = 1 InPkts
Duration = 10
Time Remaining = 0
Requested Size = 10000
Granted Size = 100
Report 1
-------------------
Rate = 3
Address = 0.1.f4.6.2e.40
To Next Page
Loading...
