Enterasys Matrix 2G4072-52 - Show Cdp

Discovery Protocols Command Set
Enterasys Discovery Protocol
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-5
3.2.2.1 show cdp
Use this command to display the status of the CDP discovery protocol and message interval on one
or more ports.
show cdp [port-string]
Syntax Description
Command Defaults
If port-string is not specified, all CDP information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display CDP information for ports fe.1.1 through fe.1.9:
port-string (Optional) Displays CDP status for a specific port. For a
detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix(rw)->show cdp fe.1.1-9
CDP Global Status : enabled
CDP Versions Supported : 0x0 0x38
CDP Hold Time : 180
CDP Authentication Code : 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
0x0 0x0 0x0
CDP Transmit Frequency : 60
Port Status
-----------------
fe.1.1 auto-enable
fe.1.2 auto-enable
fe.1.3 auto-enable
fe.1.4 auto-enable
fe.1.5 auto-enable
fe.1.6 auto-enable
fe.1.7 auto-enable
fe.1.8 auto-enable
fe.1.9 auto-enable