Discovery Protocols Command Set
Enterasys Discovery Protocol
3-6 Matrix DFE-Platinum and Diamond Series Configuration Guide
Table 3-1 provides an explanation of the command output.
Table 3-1 show cdp Output Details
Output What It Displays...
CDP Global Status Whether CDP is globally auto-enabled, enabled or disabled. The default
state of auto-enabled can be reset with the set cdp state command. For
details, refer to Section 3.2.2.2.
CDP Versions
Supported
CDP version number(s) supported by the device.
CDP Hold Time Minimum time interval (in seconds) at which CDP configuration
messages can be set. The default of 180 seconds can be reset with the
set cdp hold-time command. For details, refer to Section 3.2.2.5.
CDP Authentication
Code
Authentication code for CDP discovery protocol. The default of
00-00-00-00-00-00-00-00 can be reset using the set cdp auth
command. For details, refer to Section 3.2.2.3.
CDP Transmit
Frequency
Frequency (in seconds) at which CDP messages can be transmitted. The
default of 60 seconds can be reset with the set cdp interval command.
For details, refer to Section 3.2.2.4.
Port Port designation. For a detailed description of possible port-string
values, refer to Section 4.1.1.
Status Whether CDP is enabled, disabled or auto-enabled on the port.
To Next Page
Loading...
Need help?
General