Enterasys Matrix 2G4072-52 - Show Spantree Hello

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-43
6.2.1.30 show spantree hello
Use this command to display the Spanning Tree hello time.
show spantree hello
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the Spanning Tree hello time:
Matrix(rw)->show spantree hello
Bridge Hello Time is set to 2 seconds