SNMP Configuration Command Set
Configuring SNMP MIB Views
5-36 Matrix DFE-Platinum and Diamond Series Configuration Guide
5.3.4.2 show snmp context
Use this command to display the context list configuration for SNMP’s view-based access control.
An SNMP context is a collection of management information that can be accessed by an SNMP
agent or entity. The default context allows all SNMP agents to access all management information
(MIBs). When created using the set snmp access command (Section 5.3.3.2), other contexts can be
applied to limit access to a subset of management information and to permit SNMP access from one
or more routing modules.
show snmp context
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display a list of all SNMP contexts known to the device:
Matrix(rw)->show snmp context
--- Configured contexts:
default context (all mibs)
router2
router3
To Next Page
Loading...
Need help?
General