General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-77
2.2.3.27 set system location
Use this command to identify the location of the system.
set system location [string]
Syntax Description
Command Defaults
If string is not specified, the location name will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system location string:
string (Optional) Specifies a text string that indicates where
the system is located.
NOTE: A location string containing a space in
the text must be enclosed in quotes as shown
in the example below.
Matrix(rw)->set system location “Bldg N32-04 Closet 9”
To Next Page
Loading...
