Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-65
6.2.1.52 set spantree maxhops
Use this command to set the Spanning Tree maximum hop count. This is the maximum number of
hops that the information for a particular Spanning Tree instance may traverse (via relay of
BPDUs within the applicable MST region) before being discarded.
set spantree maxhops max_hop_count
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the maximum hop count to 40:
max_hop_count Specifies the maximum number of hops allowed. Valid
values are 0 to 255. Default value is 20.
Matrix(rw)->set spantree maxhops 40
To Next Page
Loading...
