IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12-92 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.8.13 ip slb vserver
Use this command to identify an LSNAT virtual server and to access or enable the virtual server
load balance (SLB) configuration mode.
ip slb vserver vserver-name
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command deletes the virtual server from the LSNAT
configuration:
no ip slb vserver vserver-name
Command Type
Router command.
Command Mode
Global configuration mode: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to identify a virtual server named “virtual-http” and enable configuration
mode for that virtual server. Note that this example also includes the configuration of the server
farm to which this virtual server will be associated.
vserver-name Specifies a virtual server name.
Matrix>Router1(config)#ip slb serverfarm httpserver
Matrix>Router1(config-slb-sfarm)#real 10.1.2.1 port 80
Matrix>Router1(config-slb-real)#inservice
Matrix>Router1(config-slb-real)#exit
Matrix>Router1(config-slb-sfarm)#real 10.1.2.3 port 80
Matrix>Router1(config-slb-real)#inservice
Matrix>Router1(config-slb-real)#exit
Matrix>Router1(config-slb-sfarm)#exit
Matrix>Router1(config)#ip slb vserver virtual-http
Matrix>Router1(config-slb-vserver)#
To Next Page
Loading...
Need help?
General