Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-63
3.2.4.25 clear lldp port tx-tlv
Use this command to clear the optional LLDP and LLDP-MED TLVs to be transmitted in
LLDPDUs by the specified port or ports to the default value of disabled.
clear lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap]
[mgmt-addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr]
[max-frame] [med-cap] [med-pol] [med-loc] [med-poe]} port-string
Syntax Description
all Disable all optional TLVs from being transmitted in
LLDPDUs.
port-desc Disable the Port Description optional basic LLDP TLV
from being transmitted in LLDPDUs.
sys-name Disable the System Name optional basic LLDP TLV from
being transmitted in LLDPDUs.
sys-desc Disable the System Description optional basic LLDP TLV
from being transmitted in LLDPDUs.
sys-cap Disable the System Capabilities optional basic LLDP
TLV from being transmitted in LLDPDUs.
mgmt-addr Disable the Management Address optional basic LLDP
TLV from being transmitted in LLDPDUs.
vlan-id Disable the Port VLAN ID IEEE 802.1 Extensions TLV
from being transmitted in LLDPDUs.
stp Disable the Spanning Tree information defined by
Protocol Identity IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
lacp Disable the LACP information defined by Protocol
Identity IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
gvrp Disable the GVRP information defined by Protocol
Identity IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
mac-phy Disable the MAC-PHY Configuration/Status IEEE 802.3
Extensions TLV from being transmitted in LLDPDUs.
To Next Page
Loading...
Need help?
General