General Configuration Command Set
Configuring Power over Ethernet (PoE)
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-111
2.2.5.14 set inlinepower psetrap
Use this command to enable or disable the sending of an SNMP trap message for a module
whenever the status of its ports changes, or whenever the module’s PoE usage threshold is crossed.
The module’s PoE usage threshold must be set using the set inlinepower threshold command as
described in Section 2.2.5.10.
set inlinepower psetrap {disable | enable} module-number
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable PoE trap messaging on module 1:
disable | enable Disables or enables PoE trap messaging.
module-number Specifies the module on which to disable or enable trap
messaging.
Matrix(rw)->set inlinepower psetrap enable 1
To Next Page
Loading...
