Policy Classification Configuration Command Set
Configuring Policy Profiles
8-20 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.1.15 set policy maptable
Use this command to set the Set VLAN ID - Policy Profile mappings table.
set policy maptable {vlan-list profile-index | response {tunnel | policy | both}}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the Policy Profile mappings table for VLAN 3 and for Policy ID 8:
This example shows how to use both tunnel and policy attributes in the RADIUS response for the
Policy Profile mappings .
vlan-list VLAN ID or range of IDs (1 to 4094)
profile-index Policy ID (1 to 1023)
response tunnel |
policy | both
Indicates which attributes to use from RADIUS response.
tunnel - Apply the vlan-tunnel attribute
policy - Apply the filter-id attribute
both - Apply both attributes
Matrix(rw)->set policy maptable 3 8
Matrix(rw)->set policy maptable response both
To Next Page
Loading...
