Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-98 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.6 clear spantree portadmin
Use this command to reset the default Spanning Tree admin status to enable on one or more ports.
clear spantree portadmin port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the default Spanning Tree admin state to enable on fe.1.12:
port-string Resets the default admin status on specific port(s). For a
detailed description of possible port-string values, refer
to Section 4.1.1.
Matrix(rw)->clear spantree portadmin fe.1.12
To Next Page
Loading...
