IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-7
10.4.2 Configuring IGMP
Purpose
To display and set IGMP configuration parameters, including query interval and response time
settings, and to create and configure static IGMP entries.
Commands
The commands used to configure IGMP are listed below and described in the associated sections as
shown.
• show igmp query (Section 10.4.2.1)
• set igmp query-enable (Section 10.4.2.2)
• set igmp query-disable (Section 10.4.2.3)
• show igmp grp-full-action (Section 10.4.2.4)
• set igmp grp-full-action (Section 10.4.2.5)
• show igmp config (Section 10.4.2.6)
• set igmp config (Section 10.4.2.7)
• set igmp delete (Section 10.4.2.8)
• show igmp groups (Section 10.4.2.9)
• show igmp static (Section 10.4.2.10)
• set igmp add-static (Section 10.4.2.11)
• set igmp remove-static (Section 10.4.2.12)
• show igmp protocols (Section 10.4.2.13)
• set igmp protocols (Section 10.4.2.14)
• clear igmp protocols (Section 10.4.2.15)
• show igmp vlan(Section 10.4.2.16)
• show igmp reporters(Section 10.4.2.17)
• show igmp flow(Section 10.4.2.18)
• show igmp counters(Section 10.4.2.19)
• set igmp number-groups (Section 10.4.2.20)
• show igmp number-groups (Section 10.4.2.21)
To Next Page
Loading...
Need help?
General