General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-79
2.2.3.29 set width
Use this command to set the number of columns for the terminal connected to the device’s console
port. The length of the CLI is set using the set length command as described in Section 2.2.3.30.
set width screenwidth
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the terminal columns to 50:
screenwidth Sets the number of terminal columns. Valid values are 50 to
150.
Matrix(rw)->set width 50
To Next Page
Loading...
