Logging And Network Management Command Set
Configuring NetFlow
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-165
11.2.8.10 set netflow export-version
Use this command to set the NetFlow flow record format used to export data. Refer to Version
Support on page 153 for more information about NetFlow version support. Use the show netflow
config command (Section 11.2.8.1) to display the current NetFlow version.
set netflow export-version {5 | 9}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write
Example
This example shows how to set the flow record format to Version 9
:
5 | 9 Specify the NetFlow flow record format to use when
exporting NetFlow packets, either Version 5 or 9.
The default is Version 5.
Matrix(rw)->set netflow export-version 9
To Next Page
Loading...
Need help?
General