SNMP Configuration Command Set
Configuring SNMP Target Addresses
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-47
5.3.6.1 show snmp targetaddr
Use this command to display SNMP target address information.
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Syntax Description
Command Defaults
• If targetAddr is not specified, entries for all target address names will be
displayed.
• If not specified, entries of all storage types will be displayed for a target
address.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNMP target address information:
Table 5-9 shows a detailed explanation of the command output.
targetAddr (Optional) Displays information for a specific target
address name.
volatile |
nonvolatile |
read-only
(Optional) When target address is specified, displays
target address information for a specific storage type.
Matrix(rw)->show snmp targetaddr
Target Address Name = labmachine
Tag List = v2cTrap
IP Address = 10.2.3.116
UDP Port# = 162
Target Mask = 255.255.255.255
Timeout = 1500
Retry count = 4
Parameters = v2cParams
Storage type = nonVolatile
Row status = active
To Next Page
Loading...
