General Configuration Command Set
Gathering Technical Support Information
2-158 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.13.1 show support
Use this command to display output for technical support-related commands.
show support [filename]
Syntax Description
Command Defaults
The following commands are executed:
• show version (Section 2.2.3.25)
• show system hardware (Section 2.2.3.8)
• show vlan (Section 7.3.1.1)
• show vlan static (Section 7.3.1.1)
• show logging all (Section 11.2.1.1)
• show snmp counters (Section 5.3.1.2)
• show port status (Section 4.3.2.2)
• show spantree status (Section 6.2.1.1)
• show spantree blockedports (Section 6.2.2.9)
• show ip address (Section 2.2.3.1)
• show ip route (Section 11.2.5.6)
• show netstat (Section 11.2.2.4)
• show arp (Section 11.2.5.1)
• show system utilization (Section 2.2.3.9)
• show config (Section 2.2.9.3)
Command Type
Switch command.
Command Mode
Read-Only.
filename (Optional) Filename (slotN/name) to save output.