Routing Protocol Configuration Command Set
Configuring IRDP
13-86 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.5.5 ip irdp preference
Use this command to set the IRDP preference value for an interface. This value is used by IRDP to
determine the interface’s selection as a default gateway address.
ip irdp preference preference
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the interface’s IRDP preference value to the
default of 0:
no irdp preference
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the IRDP preference value to 80000000 seconds on VLAN 1:
preference Specifies the value to indicate the interface’s use as a
default router address. Valid values are -2147483648 to
2147483647. The value of 80000000 indicates that the
address, even though it may be advertised, is not to be
used by neighboring hosts as a default router address.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip irdp preference 80000000
To Next Page
Loading...
Need help?
General