Enterasys Matrix 2G4072-52 - Set Inlinepower Management

General Configuration Command Set
Configuring Power over Ethernet (PoE)
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-109
2.2.5.12 set inlinepower management
Use this command to set the PoE management mode on a specified module.
set inlinepower management {realtime | class} module-number
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the PoE management mode to “class” on module 1:
realtime Manages power based on the actual power consumption
of the ports.
class Manages power based on the IEEE 802.3af definition of
the class upper limit, except classes 0 and 4, for which the
actual power consumption is used.
module-number Specifies the module on which to set the PoE
management mode.
Matrix(rw)->set inlinepower management class 1