General Configuration Command Set
Setting Basic Device Properties
2-54 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3.9 show system utilization
Use this command to display system resource utilization information.
show system utilization [cpu | process | storage] [slot slot]
Syntax Description
Command Defaults
• If not specified, CPU, process, and storage system utilization information will
be displayed.
• If not specified, information for all modules will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display all system utilization information for the module in slot 1:
cpu | process |
storage
(Optional) Displays total CPU, individual process, or
storage resource utilization only.
slot slot (Optional) Displays system resource utilization for a
specific module.
Matrix(rw)->show system utilization slot 1
CPU Utilization Threshold Traps enabled: Threshold = 80.0%
Total CPU Utilization:
Slot CPU 5 sec 1 min 5 min
---------------------------------------------------
1 1 3.6% 3.0% 3.0%
** Output continued on next page **
To Next Page
Loading...
Need help?
General