Routing Protocol Configuration Command Set
Configuring OSPF
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-73
13.2.3.29 clear ip ospf process
Use this command to reset the OSPF process. This will require adjacencies to be reestablished and
routes to be reconverged.
clear ip ospf process process-id
Syntax Description
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router1#
Command Defaults
None.
Example
This example shows how to reset OSPF process 1:
process-id Specifies the process ID, an internally used identification
number for each instance of the OSPF routing process run
on a router. Valid values are 1 to 65535.
Matrix>Router1#clear ip ospf process 1
To Next Page
Loading...
