SNMP Configuration Command Set
Configuring SNMP Users, Groups and Communities
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-13
5.3.2.1 show snmp user
Use this command to display information about SNMP users. These are people registered to access
SNMP management.
show snmp user [list] | [user] | [remote remote ] [volatile | nonvolatile |
read-only]
Syntax Description
Command Defaults
• If list is not specified, detailed SNMP information will be displayed.
• If user is not specified, information about all SNMP users will be displayed.
• If remote is not specified, user information about the local SNMP engine will
be displayed.
• If not specified, user information for all storage types will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
list (Optional) Displays a list of registered SNMP user
names.
user (Optional) Displays information about a specific user.
remote remote (Optional) Displays information about users on a specific
remote SNMP engine.
volatile |
nonvolatile |
read-only
(Optional) Displays user information for a specified
storage type.
To Next Page
Loading...
