Routing Protocol Configuration Command Set
Configuring DVMRP
13-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.4.2 ip dvmrp metric
Use this command to configure the metric associated with a set of destinations for DVMRP reports.
ip dvmrp metric metric
Syntax Description
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set a DVMRP of 16 on VLAN 1:
metric Specifies a metric associated with a set of destinations for
DVMRP reports. Valid values are from 0 to 31. Entering
a 0 value will reset the metric back to the default value of
1.
NOTE: To reset the DVMRP metric back to the default value of 1, enter ip dvmrp
metric 0.
Matrix>Router1(config-if(Vlan 1))#ip dvmrp metric 16
To Next Page
Loading...
