VLAN Configuration Command Set
Configuring the VLAN Egress List
7-34 Matrix DFE-Platinum and Diamond Series Configuration Guide
7.3.4.4 show vlan dynamic egress
Use this command to display which VLANs are currently enabled for VLAN dynamic egress.
show vlan dynamicegress [vlan-list]
Syntax Description
Command Defaults
If vlan-list is not specified, status for all VLANs where dynamic egress is enabled
will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display which VLANs are enabled for dynamic egress:
vlan-list (Optional) Displays dynamic egress status for specific
VLAN(s).
Matrix(rw)->show vlan dynamicegress
VLAN 1 is enabled
VLAN 101 is enabled
VLAN 102 is enabled
VLAN 105 is enabled
To Next Page
Loading...
