Port Priority and Rate Limiting Configuration Command Set
Configuring Port Traffic Rate Limiting
9-20 Matrix DFE-Platinum and Diamond Series Configuration Guide
9.3.4.3 clear port ratelimit
Use this command to clear rate limiting parameters for one or more ports.
clear port ratelimit port-string [index]
Syntax Description
Command Defaults
If not specified, all index entries will be reset.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear all rate limiting parameters on port fe.2.1:
port-string Specifies the port(s) on which to clear rate limiting. For
a detailed description of possible port-string values,
refer to Section 4.1.1.
index (Optional) Specifies the associated resource index to be
reset.
Matrix(rw)->clear port ratelimit fe.2.1
To Next Page
Loading...
Need help?
General