Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
11-98 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.5 Managing Switch Network Addresses and Routes
Purpose
To display, add or delete switch ARP table entries, to enable or disable RAD (Runtime Address
Discovery) protocol, to display, add or delete IP routing table addresses, and to display MAC
address information.
Commands
Commands to manage switch network addresses and routes are listed below and described in the
associated section as shown.
• show arp (Section 11.2.5.1)
• set arp (Section 11.2.5.2)
• clear arp (Section 11.2.5.3)
• show rad (Section 11.2.5.4)
• set rad (Section 11.2.5.5)
• show ip route (Section 11.2.5.6)
• traceroute (Section 11.2.5.7)
• set ip route (Section 11.2.5.8)
• clear ip route (Section 11.2.5.9)
• show port mac (Section 11.2.5.10)
• show mac(Section 11.2.5.11)
• set mac (Section 11.2.5.12)
• clear mac (Section 11.2.5.13)
• show newaddrtrap (Section 11.2.5.14)
• set newaddrtrap (Section 11.2.5.15)
• show movedaddrtrap (Section 11.2.5.16)
• set movedaddrtrap (Section 11.2.5.17)
To Next Page
Loading...
Need help?
General