General Configuration Command Set
Downloading a New Firmware Image
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-117
2.2.6.1 Downloading from an FTP or TFTP Server
To perform an FTP or TFTP download, proceed as follows:
1. If you have not already done so, set the device’s IP address using the set ip address command
as detailed in Section 2.2.3.2.
2. Download a new image file using the copy command as detailed in Section 2.2.9.5.
You can now set the device to load the new image file at startup using the set boot system command
as described in Section 2.2.7.2.
2.2.6.2 Downloading via the Serial Port
To download device firmware via the serial (console) port, proceed as follows:
1. With the console port connected, power up the device. The following message displays:
2. Before the boot up completes, press any key. The following boot menu options screen displays.
Boot ROM Initialization, Version 01.00.01
Copyright (c) 2004 Enterasys Networks, Inc.
SDRAM size: 128 MB
Testing SDRAM.... PASSED.
Loading Boot Image: 01.00.02... DONE.
Uncompressing Boot Image... DONE.
Press any key to enter System Image Loader menu
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM (64KB).
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Run Flash Diagnostics
7 - Update Boot Code
8 - Delete operational code
9 - Reset the system
10 - Restore Configuration to factory defaults (delete config files)
To Next Page
Loading...
Need help?
General