Logging And Network Management Command Set
Configuring RMON
11-72 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.4.17 set rmon host status
Use this command to enable an RMON host entry.
set rmon host status index enable
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable RMON host entry 1:
index Specifies an index number for this entry. Maximum
number of entries is 5. Maximum value is 65535.
enable Enables this host entry.
Matrix(rw)->set rmon host status 1 enable
To Next Page
Loading...
