Security Configuration Command Set
Configuring RADIUS
14-12 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.2.2 set radius
Use this command to enable, disable, or configure RADIUS authentication.
set radius {[enable | disable] [retries number-of-retries] [timeout timeout]
[server {index ip-address port [secret-value]} [realm {management-access |
network-access | any} {index | all}]}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
NOTE: The RADIUS client can only be enabled on the switch once a RADIUS server is
online, and its IP address(es) has been configured with the same password the RADIUS
client will use.
enable | disable Enables or disables the RADIUS client.
retries
number-of-retries
Specifies the number of retry attempts before the RADIUS
server times out. Valid values are from 1 to 10. Default is 3.
timeout timeout Specifies the maximum amount of time (in seconds) to
establish contact with the RADIUS server before retry
attempts begin. Valid values are from 1 to 30. Default is 20
seconds.
server index
ip_address port
Specifies the index number, IP address and the UDP
authentication port for the RADIUS server.
secret-value (Optional) Specifies an encryption key to be used for
authentication between the RADIUS client and server.
realm
management
-access |
network-access |
any
(Optional) Restricts the RADIUS server realm to
management or network access authentication, or allows it
to perform all authentications.
index | all Applies the server realm setting to a specific server or to all
servers.
To Next Page
Loading...
