IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-25
10.4.2.16 show igmp vlan
Use this command to display IGMP information for a specific VLAN.
show igmp vlan [vlan-list]
Syntax Description
Command Defaults
None
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display igmp information for vlan 12:
vlan vlan-list Show IGMP info for the given VLAN.
Matrix(rw)->show igmp vlan 12
IGMP Vlan 12 Info
IGMP query state : Enabled
QueryInterval(sec.) : 125
Status : Active
IGMP Version : 2
Querier : 2.25.0.1
QueryMaxResponseTime(sec.) : 10
Robustness : 2
LastMemberQueryIntvl(sec.) : 10
QuerierUpTime : 4 D 23 H 8 M
Router(s) on ports : none.
Egressing ports : lag.0.1-2,4
To Next Page
Loading...
Need help?
General