IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-89
12.2.8.12 show ip slb vservers
Use this command to display server load balancing virtual server information.
show ip slb vservers [detail | virtserver-name [detail]]
Syntax Description
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
If no parameters are entered, summary information about all configured virtual
servers will be displayed.
If detail is not specified, summary information will be displayed.
Examples
This example shows how to display summary information about all LSNAT virtual servers:
detail (Optional) Displays detailed output for a specific virtual
server or for all configured virtual servers.
virtserver-name (Optional) Specifies a virtual server name for which to
display information.
Matrix Router1(config)#>show ip slb vservers
vserv persistence service
virt-serv vserv-ip-addr port server-farm type level ins name
------------------------------------------------------------------------------
telnet 192.169.10.1 23 matrix STICKY 200 IS
wftpd 192.169.10.3 21 ftpserver SSL 240 IS
five 3.3.3.3 80 ten TCP 41 IS
test 192.169.10.88 80 big TCP 240 IS ftp
To Next Page
Loading...
Need help?
General