Enterasys Matrix 2G4072-52 - Page 1048

IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12-88 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.8.11 weight
Use this command to specify the weight load number of a real server that is a member of an LSNAT
server farm.
weight weight-number
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the weight load number to the default value
of 1:
no weight weight-number
Command Type
Router command.
Command Mode
SLB Real Server Configuration mode: Matrix>Router1(config-slb-real)#
Command Defaults
None.
Example
This example shows how to set the weight load number to 100 on the real server at IP 10.1.2.3 in
the “httpserver” server farm:
weight-number Specifies the weight load number. Valid values are 1-255.
Matrix>Router1(config)#ip slb serverfarm httpserver
Matrix>Router1(config-slb-sfarm)#real 10.1.2.3 port 80
Matrix>Router1(config-slb-real)#faildetect ping-int 10 ping-retries 6
Matrix>Router1(config-slb-real)#maxconns 20
Matrix>Router1(config-slb-real)#weight 100
Matrix>Router1(config-slb-real)#inservice