Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-117
11.2.5.14 show newaddrtraps
Use this command to display the status of MAC address traps on one or more ports.
show newaddrtrap [port-string]
Syntax Description
Command Defaults
If port-string is not specified, MAC address traps for all ports will be displayed.
Command Mode
Read-Only.
Example
This example shows how to display the status of MAC address traps on ge.1.1 through 3:
port-string (Optional) Displays MAC address traps for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.1.
Matrix(rw)->show newaddrtrap
New Address Traps Globally disabled
Port Enable State
--------- ------------
ge.1.1 disabled
ge.1.2 disabled
ge.1.3 disabled
To Next Page
Loading...
