Enterasys Matrix 2G4072-52 - Configuring Simple Network Time Protocol (SNTP)

Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-121
11.2.6 Configuring Simple Network Time Protocol (SNTP)
Purpose
To configure the Simple Network Time Protocol (SNTP), which synchronizes device clocks in a
network.
Commands
Commands to configure SNTP are listed below and described in the associated section as shown.
• show sntp (Section 11.2.6.1)
• set sntp client (Section 11.2.6.2)
• clear sntp client (Section 11.2.6.3)
• set sntp server (Section 11.2.6.4)
• clear sntp server (Section 11.2.6.5)
• set sntp broadcastdelay (Section 11.2.6.6)
• clear sntp broadcastdelay (Section 11.2.6.7)
• set sntp poll-interval (Section 11.2.6.8)
• clear sntp poll-interval (Section 11.2.6.9)
• set sntp poll-retry (Section 11.2.6.10)
• clear sntp poll-retry (Section 11.2.6.11)
• set sntp poll-timeout (Section 11.2.6.12)
• clear sntp poll-timeout (Section 11.2.6.13)
• show timezone (Section 11.2.6.14)
• set timezone (Section 11.2.6.15)
• clear timezone (Section 11.2.6.16)