Port Configuration Command Set
Setting Console Port Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-13
4.3.1.7 set console flowcontrol
Use this command to set the type of flow control for one or more console ports.
set console flowcontrol {none | ctsrts | dsrdtr} [port-string]
Syntax Description
Command Defaults
If port-string is not specified, flow control will be set for all console ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable DSR/DTR flow control for console port com.1.1:
none Disables all hardware flow control.
ctsrts Enables CTS/RTS (Clear to Send/Request to Send) hardware
flow control.
dsrdtr Enables DSR/DTR (Data Set Ready/Data Terminal Ready)
hardware flow control.
port-string (Optional) Sets flow control for specific console port(s).
Matrix(rw)->set console flowcontrol dsrdtr com.1.1
To Next Page
Loading...
Need help?
General