Enterasys Matrix 2G4072-52 - Set Port Advertise

Port Configuration Command Set
Setting Auto-Negotiation and Advertised Ability
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-59
4.3.6.7 set port advertise
Use this command to enable or disable and to configure the advertised ability on one or more ports.
set port advertise port-string [10t] [10tfd] [100tx] [100txfd] [1000x] [1000xfd]
[1000t] [1000tfd] [pause] [apause] [spause] [bpause]
Syntax Description
Command Defaults
At least one optional parameter must be specified.
Command Type
Switch command.
port-string Specifies the port(s) for which to set advertised ability. For
a detailed description of possible port-string values, refer to
Section 4.1.1.
10t (Optional) Advertises 10BASE-T half duplex mode.
10tfd (Optional) Advertises 10BASE-T full duplex mode.
100tx (Optional) Advertises 100BASE-TX half duplex mode.
100txfd (Optional) Advertises 100BASE-TX full duplex mode.
1000x (Optional) Advertises 1000BASE-X, -LX, -SX, -CX half
duplex mode.
1000xfd (Optional) Advertises 1000BASE-X, -LX, -SX, -CX full
duplex mode.
1000t (Optional) Advertises 1000BASE-T half duplex mode.
1000tfd (Optional) Advertises 1000BASE-T full duplex mode.
pause (Optional) Advertises PAUSE for full-duplex links.
apause (Optional) Advertises asymmetric PAUSE for full-duplex
links.
spause (Optional) Advertises symmetric PAUSE for full-duplex
links.
bpause (Optional) Advertises asymmetric and symmetric PAUSE
for full-duplex links