Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
4-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.8.8 clear linkflap action
Use this command to clear reactions to a link flap violation.
clear linkflap action [port-string} {disableInterface | gensyslogentry | gentrap
| all}
Syntax Description
Command Defaults
If port-string is not specified, actions will be cleared on all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear all link flap violation actions on all ports:
port-string (Optional) Specifies the port(s) on which to clear the link
flap action. For a detailed description of possible
port-string values, refer to Section 4.1.1.
disableInterface |
gensyslogentry |
gentrap | all
Clears the reaction of:
• Disabling the interface
• Generating a Syslog entry
• Generating an SNMP trap message, or
• All of the above.
Matrix(rw)->clear linkflap action all
To Next Page
Loading...
Need help?
General