IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12-76 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.8.2 ip slb ftpctrlport
Use this command to specify an FTP control port for load balancing functionality. By default, this
is port 21.
ip slb ftpctrlport port-number
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the FTP control port to 21:
no ip slb ftpctrlport
Command Type
Router command.
Command Mode
Global configuration mode: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to specify port 46 as the FTP control port for server load balancing:
port-number Specifies an FTP port number
Matrix>Router1(config)#ip slb ftpctrlport 46
To Next Page
Loading...
Need help?
General