Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-115
14.3.8.13 set cep initialize
Use this command to clear all existing CEP connections for one or more CEP-enabled ports. This
command is similar to the clear cep users command.
set cep initialize [port-string]
Syntax Description
Command Defaults
If no port-string is specified, all existing CEP connections on all ports are cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to re-initialize CEP ports fe.1.3-5
:
port-string (Optional) Specifies the CEP-enabled port(s) to clear
existing CEP connections. This must be a port-string
enabled for CEP using the set cep port command as
described in Section 14.3.8.6. For a detailed description of
possible port-string values, refer to Section 4.1.1.
Matrix>set cep initialize fe.1.3-5
To Next Page
Loading...
