Enterasys Matrix 2G4072-52 - Set Multiauth Session-Timeout

Security Configuration Command Set
Configuring Multiple Authentication
14-150 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.10.15set multiauth session-timeout
Use this command to set multiple authentication session-timeout values, for an active session.
set multiauth session-timeout [cep | dot1x | mac | pwa] timeout
Syntax Description
Command Defaults
If no authentication type is specified, the timeout value is set for all types.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the session-timeout value for an active session, for cep and mac
authentication to 500 seconds:
This example shows how to set the session-timeout value for an active session, for all the
authentication types to 600 seconds:
cep | dot1x | mac |
pwa
(Optional) Specifies the authentication type:
• cep — Enterasys Convergence End Point Authentication
• dot1x— IEEE 802.1X Port-Based Network Access
Control
• mac — Enterasys Mac Authentication
• pwa — Enterasys Port Web Authentication
timeout Number of seconds before session timeout.
Range = 0-65535, if set to zero the session never times out.
Matrix(rw)->set multiauth session-timeout cep 500
Matrix(rw)->set multiauth session-timeout mac 500
Matrix(rw)->set multiauth session-timeout 600