Logging And Network Management Command Set
Monitoring Network Events and Status
11-34 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.2.6 show users
Use this command to display information about the active console port or Telnet session(s) logged
in to the switch.
show users
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to use the show users command. In this output, there are two Telnet users
logged in with Read-Write access privileges from IP addresses 134.141.192.119 and
134.141.192.18:
Matrix(rw)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
To Next Page
Loading...
Need help?
General