Routing Protocol Configuration Command Set
Configuring OSPF
13-66 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.3.26 show ip ospf interface
Use this command to display OSPF interface related information, including network type, priority,
cost, hello interval, and dead interval.
show ip ospf interface [vlan vlan-id]
Syntax Description
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
If vlan-id is not specified, OSPF statistics will be displayed for all VLANs.
Example
This example shows how to display all OSPF related information for VLAN 1:
Table 13-4 provides an explanation of the command output.
vlan vlan-id (Optional) Displays OSPF information for a specific VLAN.
This VLAN must be configured for IP routing as described
in Section 2.3.1.
Matrix>Router1#show ip ospf interface vlan 1
Vlan 1 is UP
Internet Address 182.127.63.2 Mask 255.255.255.0,Area 0.0.0.0
Router ID 182.127.64.1,Network Type BROADCAST,Cost: 10
Transmit Delay is 1 sec,State BACKUPDR,Priority 1
Designated Router id 182.127.62.1, Interface addr 182.127.63.1
Backup Designated Router id 182.127.63.2,
Timer intervals configured, Hello 10,Dead 40,Wait 40,Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 182.127.63.1 (Designated Router)
To Next Page
Loading...
Need help?
General